I made a wet tumbler because I had an old rubber lined drum.
It works very well.
The first 2 batches of brass I tumbled came out great , looked new, ( was old black range brass.)
Last few batches I have done are clean but not bright like before.
My tumbler tumbles slow and quiet...
I have a military/police contract Browning, made in middle 70s.
It is blue and has a set of wrap around Pachmayrs.
Using original parkerized/Blue mags, the mags rubs the flat sear spring at the rear of the mag well.
I took the grips off in order to see what was happening and that is...
Not knowing where to ask this , I thought I would here since there are many all knowing that frequent here.
Back in the middle 80s I had 2 Remington model sevens
that were new and both 243 cal. and nice little rifles with nice straight grain walnut stocks.
Not like the pewter ...
I have a nice Mauser bolt that I need to use and all is good to go but the firing pin hole appears elongated some from primer corrosion?
The face could be cleaned up some and may take care of that , the face looks to be pretty good and will clean without going too deep but If I clean it and...
Anyone know the number of the Leupold or Redfield 1 piece mounts that will allow the clip charger lip to stay on the bridge? ( this used to be printed in thier application files).
Also did at some time past,either Leupold , Redield or Burris make a 1 piece dovetail type mount that used BOTH...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.