Local pawn shop has an Iver Johnson single action 44-40 for sale. has some bluing wear but the action is tight. They are asking $350 but might go less... Does anyone have one of these and if so what can you tell me about them? Good guns? junk?
have a Norinco Ak that I want to take the thread protector off and installed a flash suppresor. There appears to be a pin sticking out of the front sight and the schematic I looked at said it is spring loaded however when I try to push it in it doesn't move. I'm gonna soak in in oil tonight and...
I am trying to find a picture or video or something on a press I saw in a shop years ago. If I remember right it was green, a progressive but instead of rotating it moved the cases from one side to another. They would come out move over and back in, the dies were set into it in a line...
I just traded for a Ruger 45LC Blackhawk Bisley and although it shoots great I have a question about the trigger and hope someone on here and help me.
When the hammer is down and you go to cock it there is a small hang in it like the trigger or hammer is catching on something. If you pull...
I just bought an old muzzleloading shotgun today and was wanting some help finding more info on it. It is a double barrel that is marked Goddard (HRANTED) ? It has pheasants engraved on both sides on ground and flying. It still has matching hammers and screws.
The fit of the hardware isn't...
I have one of these and was wanting some information about it. This one works double action only although it has a hammer spur. Also the cylinder rotates and locks up ok but if your not pulling the trigger it will freewheel, I don't think it's supposed to do that.....
Could anyone tell me...
When loading for my Vaquero 44-40 it seems no matter how careful I am I will get some bullets in crooked, not really bad but enough to cause problems chambering them. I have been taking the decapper out of my sizing dies and running them back through it. Does anyone else have a problem with...
Friend has a Marlin 1894 44 mag that the bolt doesn't seem to close all the way. It's not bad enough that it won't fire but the cover on the side likes about 1/16 - 1/132 closing all the way.
What can cause this?
Guy at work just got a Marlin 44 Mag and the bolt doesn't seem to want to go all the way to the front. It will lock up and fire the shell but he said (and sent me pictures ) that the bolt doesn't go all the way forward and he gets alot of blowby.
In the pictures you can see that the cover...
I'm loading some 105 gr lead bullets for my 380s. I got on here and researched and found load data with Unique powder listed anywhere from 2.5 up to 4.0 grains. I tried 5 bullets at 3.3 and at 2.8 and they shot fine but I had serious primer cratering. I was shooting them out of a Bersa and a...
Just got back from shooting mine and was wondering if there is an easy or simple way to lighten the trigger and keep the reliability. If someone knows could you please post it? Thanks!
Did Remington change trigger assembly styles during the production run? I have 2 rifles, a 308 and a 243. The 243 's bolt will fall out so I was going to take the bolt stop out of the 308 to see how to modify the one that doesn't work to match it.
The assemblies are built differently and I...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.