Search results for query: *

The problem with the flechette used in VN was they were focused on packing more flechettes in to try and get greater lethality, or packing them too lose. When you pack flechettes in in an up/down orientation, the upside-down projectiles will push the foreward-facing ones out of pattern. Also, if...

It is actually not that tacky. Just take the POS laser of the bottom, find a decent magwell (like on a raceframe) and you have a decent race gun. But I wonder how he carries it in that paddle holster, and I like how he used the word "mod" like he just got finished playing Half-Life.

Yeh, but after you get it transfered to a local FFL dealer, pay for shipping, and come to find out it looks like unholy heck, grand total comes to 400-425. If the gun looks in great shape, the actions cycles smoothly (as smooth as you would expect from a WASR) by all means not too bad. You might...

I'm suprised no one has said Patriot Ordinance Factory. If you are looking for a good accurate rifle some of the Bushmasters and Rock River varmit rifles fit the bill quite nicely. If you want extreme tack driving, then you will have to experiment with bullets, chambers, coeficients and the...

a) Calibers for AR's can go from .22s to 50 cal (50 Beowolf). Some of the 30 cal rifles are built heaver for the round and take special mags and breaks. Since the upper receiver can detatch, you can get a veriety of calibers, barrels and configuration while keeping the same lower. No other...

Same stuff here.

Here is a pic of the shell.

And here are the pictures I promised. This is the handloaded flechette fired from a Norinco 20'' barreled coachgun w/ full choke. Entry measured 1.3 inches by RCBS reloading calipers. sheet measured 2'x2'x1/2'' @ 23-1/2 yards This is the exit. Measured same diameter as entry. This...

It actually has been known to be quite a nasty projectile. I have read that the shafts and the tails seperate and the shaft bends into a hook shape.

I would recommend trying the original style magazine(the short 10 round one). A vast majority of extended mags seem to have a problem feeding into the gun.

Sure, I'll send some today if I can find a camera. Expect them around 5 pm EST. All also see of I can find some plywood to test as well.

Thanks for the info, but what is with the inability to penetrate plywood, after a little experimenting, I was able to get 12ga sized holes of nothing but flachette at 23 yards. One time, I blew open one of those aluminum Green Gas cans, which is about 2mm thick, at 23yds.

I have seen these advertised on Cheaper Than Dirt and was wondering what are some of the laws regarding to (if any) to these projectiles.