Search results for query: *

1966 ,using 230fmj or 185jhp BUT, mainly when i use the original mag, if i use the Wilson's no problem, "I'm thinking the follower on the original may be catching in the groove and not allowing the ammo to hit the ramp at the right angle. AND they also feed fine in my other kimbers and my...

I have both, but for the price of the Kimber its a deal. *Note- check out the ramp to see if its chewed up- thats the only issue I have w/ the Ultralites- the stock mags and CM's tend to chew up the ramp and sometimes cause feeding issues. but its still a good deal even if it is the case/...

What I've percieved/ I usually take a G17/ G30 / & a Kimber stainless target 45acp to the range.... The G17 seems snappier- using WWB 115-fmj./warm-up gun/and if I have friends w/ me since its a bit cheaper for the ammo The G30 seems alot smoother- Not sure but I think because the dble...

More than likely my mother will get them- She'll be a PISTOL PACKING-AR TOTING-SHOTGUN SLINGING, MOTHER :what: , Best Armed Senior Citizen in her neighborhood. Then she can decide how to divy em up between my sibs. Sam Adams "good beer", also are there wills that you can prepare...

My Local Dealer in PA. had to send his FFL to receive a stripped AR lower and the Dealer I purchased it from sent their FFL to him. MY dealer stated " THAT IS PROPER PROCEDURE ", He said w/out the FFL from the sender he contacts them to get their FFL sent if they forgot or if they refuse he...

Chris, that would be like "Co-witnessing" but wouldn't the front sight be fuzzy/or not seen at all> being so close off the lens off the scope/ should be interesting if you can do it / the only ones I thought you could do that w/ where w/ no magnification basically redots/or holos'.

I was sent some stuff from Break-free company -called COLLECTOR , supposed to be a long storage preservative, going to try it on an older piece 1st then leave it in plastic "only" in the basement for a few months. should be intersting...........check back around JUNE 05, I figure 6 months...

you can always use them as a booster seat for the little ones..................................... Depending on the population of your area of course :D

Thanks for the info ZAK, I'm just getting into the AR's and kinda got burned on my 1st purchase :banghead: So now I'm getting as much info as I can to make an Educated decision , B4 trying to do a build/or get a custom made. It gets quite $$$ costly and educational as I found out and as the...

Did you specify barrel and twist to mstn or is it a special upper that they where running ? , And why the 1-7 7" twist? , Just trying to get info for when I get the $ to do a build? Thanks, poes

Nice, Real Nice :D. Did MSTN custom the barrel and do the upper or do they custom order the barrel from krieger then put it in the upper ? I'm really liking the darkevil one :evil:

The G17 w/ the Big Sticks, can get costly when you load 10 of em up and think it'll last like your using 10rdrs :eek: 1/2 hour later and 330 rds through er' I'm running home for more food, I realized er' appetite increased w/ my pleasure :D

Just getting er' warmed up :D

Finally got er' all cleaned up. Look :D , also cleaned the kimber custom pro eclipse ll / pics not the greatest but it works for now....

Check with the sks boards/ www.sksboards.com , GOOD LUCK , and make sure you clean the bolt and firing pin. Also they have the complete procedure to break it down all the way to get all the cosmo out.

AHHH, yes....., getting sucked into the competition THING. At 1st I really wanted to be the ON THE A-LIST, :rolleyes: , But slowly I learned>" EGO" had to be locked in the trunk w/ the piece I thought I really needed to win matches. Now, its all about fun, learning techniques, Re-learning...

And this is why I only deal w/ US postal MO's or credit card. Only once sent personal check but checked w/ vendor who recommended the seller.

I use the Break-Free CLP, * Note- recently I was using it to clean and the can lost pressure-I checked w/ the company and gave them the UPC code- Not only did they replace the Break-Free CLP but they also sent me a Bottle of "COLLECTOR" to try out, Its for long term storage "VAULT QUEENS", The...

Valkman, I was thinking I should have got one of those or similar for the AR15, but when I asked the local gunny shop they said they mainly dealt w/ tubes because the holos' washout in sunlight- have you noticed that at all ?, Or where they Bsing me just to sell their tubes. By the way the one...

Thanks again for all the replies. 1st I'm going to see if the Smithy can machine what I have, He seemed interested in what I was trying to do. If that falls through I'm going to check out all the options that all of you suggested. This started out as an inexpensive buy, and 1st time Ar to...