You would need to get the cylinder reamed out to accept 9mm andthen you would need to use 38 super moon clips. I am planning on doing this conversion on one of my 627's. I purchased an extra cylinder so I don't have to modify the original. Accuracy should be acceptable as long as your not...
S&w does not do any work on pre model number guns (including blueing). I am in the same boat as you are. Mine has been previously refinished. Gonna get the barrel chopped and have it hard cromed.
I lay the hammer block in place then set the grove in the side plate on the hammer block. Then slide the plate up the the correct position making sure the hammer block stays in the grove. Then tap the plate down and screw it tight.
I teach at a few classes with out instructors (one on one time with students). Every instructor brings their own guns. I always bring revolvers and a lot of others bring auto loaders. Throughout the class I watch them all jam at one point or another. About 20% is gun issues and the other 80% is...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.