Search results for query: *

  1. J

    Bushmaster ACR Torture Test

    +1 too
  2. J

    What weight bullet

    What weight of bullet are you guy's using to get the best MOA out of your L1A1 factory barrels. I understand that each gun is different but I just want to get a feel of where I need to start and what direction without sending to much money. I will be using Ramshot Tac powder. TIA
  3. J

    Flashlight mount AR-15 without rails

    suprised nobody mentioned duct tape:)
  4. J

    50-round drum and stock for Ruger 10/22

    plus the paracord/550 cord will keep face off the cold metal/plastic of the butler creek folding stocks when it's cold out.
  5. J

    Hornaday 150 gr SP in Hornaday 308 win dies?

    I am having problems with the case increasing it's diameter right below the shoulder when the bullet is seated in the seating die. The bullet weight is 150.5 grains and 0.308" in diameter as the box label say's. I have used virgin brass in Win and Remington brands and fired Remington brass...
  6. J

    Ar-15 Question

    +1 what they said
  7. J

    Ptr-91 jams with magtech ammo?

    Magtech = Bad I had the same problem with my L1A1. Changed out ammo and I know longer had to step on the bolt handle to eject the case.
  8. J

    Which rattle can?

    Rustoleum or Krylon? Which one seems to hold up/wear better on plastic. I have used FAL that has the old plastic that is shiny so I bought new USA made compliant parts that cheaply made and look like ****. I was wonder which paint would hold up better in a camo paint job on the plastic?
  9. J

    Middle ground between the AR and AK?

    Well you could increase your understanding of the alphabet with the letters F, A, and L to make FAL (even if it not a word). I saw two of them at my local toy store for $1000. Check them over real good and make your it's not built on a Heese receiver, Imbel being the best copy of the orginal...
  10. J

    Help me solve a problem: LnL issue

    I have the some problem with H4895. I have gotten to the point where I feel too much pressure on the handle then I raise the raise the powder-drop with my other hand so it cuts the powder then I raise the ram all the way up from there. Got tired of cases belling inward, for a lack of a better...
  11. J

    Thoughts on Clay's

    It was all they had and I didn't know any better. Nwe at reloading and first time reloading pistol. A buddy of mine picked some Universal (sp?) and I thought I would try some thing different. Is Clay's tempature sensitve like some powders are?
  12. J

    Thoughts on Clay's

    Just reloaded my first batch of 45 acp with 3.7 grains of Clay's, 230 grain Hornaday's XTP, Remington #2 1/2 LP primers with a O.A.L of 1.249''. They all went bang but it seemed like the load was a bit on the lite side. Is Clay's a always low recoil powder or was the a 3.7 grains to lite...
Back
Top