Search results for query: *

I somehow managed to lose one of the torx head ring screws on my Burris Zee ring set. What is my best option for getting a replacement? I see Brownells and Midway both sell screw assortments, but I just need one.

I'm curious about the loadings (factory and load manuals) that always have the Swede as the weak sister to all the newer cartridges. I know the case capacity is several grains of water higher than either the 260 Rem or 6.5 CM. For those of you that load this caliber, doesn't it make sense that...

I have an early model with the screw holes in the side of the action for mounting receiver sights I suppose. I got it looking pretty sad, dirty dusty and surface rust. Shoots patterns, not groups. Hard plastic buttplate. I'd like to have a gunsmith rebarrel it and put it in a nice stock. But...

I just got a new 22 on which I am going to mount a 3-9x40 scope. The LGS didn't have an appealing selection of rings to fit the pre installed weaver style bases. Is there a way to know what height rings I need to clear the objective, barely? It has to clear, but sit as low as possible. Trial and...

Mistakenly bought ten boxes of 222 Rem instead of 223. Must not have had my reading glasses on. Anyway, barring a successful attempt to cancel the order, who makes a nice rifle in that caliber? It seems CZ does...any other great ideas? Thanks!

Planning on putting together an AR, just wondering about compensators. Do compensators show any appreciable difference in recoil (muzzle rise, really) with a .223? I am going to build one that I hope my wife enjoys shooting, lightweight, comfortable grip and foreend, etc...if I put a nice optic...

I have a hankering for either a Beretta 21 or a Taurus 22B...I think the Beretta has the edge in finishing but if there are performance issues to consider, I'd like an informed opinion...I was looking hard at a Ruger LCR in 22 the other day, I'll probably get one of those too, but I am just...

I have a Colt XSE something or other...I would like to replace the full length guide rod with the standard GI, for ease in disassembly. What do I need? It looks like I just need a different guide rod, and plug. Does that do it? Thanks, Mike.

Finally found a couple boxes of winchester white box 115 grain ammo to shoot in my Christmas present. I found the mags easy to load, used the mag loader at first, but got used to doing without a while later. Gun has a nice smooth trigger for a plastic gun, much better than my buddys Glock 22...

Went to the local outdoor range (40 miles away) and found that there was no more provision for setting up targets. We used to have fence posts with webbing stretched between to attach the paper targets, no more. I need plans for a target stand that can withstand a good breeze and hold my...