Search results for query: *

Thanks. Is that the book you where talking about? That has excellent ref. info.

"The catalog description is: "Manufacturer: Leapers - Mfr# MAG2461" Yes, these are junk.

Thanks for the links. I appreciate all of your help. And ya I knew that you were joking around. Sometimes its hard to understand the toneset of emails and messages. Thanks again.

Thanks again. I guess I am going to have to break down and pay for some drawings if I am going to start collecting M1s :D

I have another question. What is the width of the follower assy grooves in a M1 Garand receiver? And what are the tab widths of the follower assy? The reason I ask is that my M1 sometimes as a problem feeding the frist round. The angled neck part of the case on the bullet is hanging against...

Charter Arms I bought one for my wife. The 1st had a late firing pin. We sent it back and they send us a different one. But this one, inside the barrel, shows were the pin that holds the barrel on has deformed the rifling. If Charter Arms can't drill and ream a hole in location, don't count...

Maybe laser etching maybe better to retrace the original numbers and letters. We have a laser etching machine at work that can adjust the letters for the contoured surface so that it is even. Stamping is a little tough to match up what has already been stamped. From what I have stamped before...

YA it comes lose during firing alright. Its dwg# is d35382 -3 SA so its seen some use. I got it welded up over the tabs that were already there and I'll be working it in to spec tonight. Thanks for all of your help! This is why I use "The High Road" because of the excellent people that make...

Yes you are right. I took another look at it last night and the channel is sqaure. I was looking at my op rod lug. I am not sure if it is suppose to be square or not. Currently it looks like it has a 45deg. angle on the lug facing away from the center of the rifle. But it has a lot of slop up...

A garand. The "v" cut should be in the bottom rail where the lug goes in to help guide the rod. The Op-rod on the bottom under the handle has a v-shaped lug. I think. Thanks for the info.

Does anyone know what the width of the op rod groove is to be? Not incluing the v cut in the groove. Just the dimension from the top lip to the bottom lip with calipers in thousands of inches. Mine is measuring .290" wide. And also what was the tolerance on this held to?:confused:

M1 rifle question Does anyone know what the width of the op rod groove is to be. Not incluing the v cut in the groove. Just the dimension from the top lip to the bottom lip with calipers in thousands of inches. Thanks guys.

Adjustable gas NCsmitty, What do you think about the adjustable gas cyclinder lock screw for the M1 rifle?

CAI M1 rifle I have a CAI M1 rifle that has some nice parts on it. I have not shot it yet but i have check the headspace my self. It check good.