9mm luger

Got a new toy. It's my plandemic osprey9 sealed and recoil boosted. Who'd da thunk the plandemic would still be going strong a slow tax stamp later? (13 or 14 months, my slowest of 6 form four silencers by far) The gun is a Beretta 92fs. To really test out this new fangled Nealon device silencer...

The gun is a mark2 semi auto sten. I have worked up a load that's kind of impressive. 11gr of AA9 compressed, with a small rifle primer for 124gr. It's a half grain over the max, uses small rifle primers. Velocity is about 1,580 +/-10 feet per second out of a 9.5inch barrel. Accuracy is between...

I would like to work up a load 9x19mm 147gr xtp with either HS-6 or AA7, kept subsonic in a carbine specifically for coyote assassination. Do I need +P brass to get the projectile moving around 1,050 to 1,100 fps or no? I was going to buy some 147gr +P to see if it was super sonic but at $30 for...

My experimentation with breech plugs for break action inline muzzleloaders using cartridges was triggered by articles about conversions of factory breech plugs to use .25 ACP cartridges or Variflame adapters in place of #209 shotgun primers, on the theory that less powerful primers give better...

Hi Guys, I have loaded thousands of plated 115 grain plated round nose Berry and Ranier for 9mm with .37 CC Lee autodisk that produces charges 4.0 to 4.4 grains of Tite Group and they all shot well from 3 different Kahrs, XD, Sig, Ruger, everything I own. My press is set up to seat the bullets...

I recently bought a large quantity of pulled 9mm jacketed (not plated) bullets. It includes all sorts of weights and all sorts of configurations. A statistically valid sample was measured with a micrometer and found all sample units to be 0.3550 to 0.3552 in diameter. I plan on treating all...

I have been searching the internet for days and i have not been able to find any reloading recipes for federal bullets. While federal bullets are not sold new as components, they are sold as pulled demilitarized or old stock. I purchased some federal hi-shok and hydra-shok for plinking before I...

I am getting ready to start working up a 9mm Luger load using HP-38 with some 115 grain bulk bullets that I bought some time ago. The bullets look like Hornady XTP bullets except that the transition from the body of the bullet to the ogive is not quite as abrupt as on the Hornady. The bullets...

I was sorting through some mixed range brass that I bought recently and came across this one. There are two shots of the same photograph; one cropped and the other color-corrected by the software: The case is brass. It is boxer primed. At this point it has been washed in a weak acid...

When I read about 9mm Luger loads, I seem to see more conversations involving 124 grain (8.0 gram) bullets rather than 115 grain (7.5 grain). Don't most military loads use 115 grain bullets? Do more civilian shooters use 124 grain than 115 grain? If so, is it just a question of personal...

I have a 9mm Storm Lake barrel that requires me to load JHPs very short in order to keep them off the landes when chambered. I have sent them to a gunsmith to have it throated so I can load longer cartridges. I included a dummy load so that he could cut the landes just enough to give me about...

Hi all! Does anyone have in their books a load for a 9mm luger 115gr XTP using the HP-38 (Hodgdon brand) powder and also 115 gr FMJ using the HP-38 powder? My manuals don't have the load out for them using this powder(Lyman and Hornady) and I see variance compared to what is listed on the...