load advice needed

I need some load information for the 700gr bullets. I'm using, lil gun and some H110 powder. I use Lil gun for 440 and 500 grain bullets, and I want to buy some 700 grain bullets from Matt's Bullets. Anyone have a good recipe for the powder and bullet combination?

Hello Id like to share a load experience and ask for some load advice. I am aware different rifles like different loads but in my experience, most like a given load and need fine tuning only. Either way. Does anyone have any experience with a good 120g GMX load for 6.5CM using H4895, Varget or...

Hi all - I'm loading up some 357mag using Berrys 158gr plated round nose bullets. I've loaded Berry's 158gr plated flat points to 1.575" before and they worked for me. If I load the RNs to the same OAL they will be seated deeper and (presumably) have a higher pressure when fired. What's a...

Based on my reading, the consensus seems to be that a 125gr JHP bullet makes for a very good defense round. Mr. Ayoob stated in an article that I read some time ago that a 125gr JHP moving between 1400fps - 1450fps is, in his opinion, a very good choice. I'd like to come up with a load recipe...

Hi All, I am a new member and first-time poster looking for a little guidance. To date, I have been loading multiple calibers but all using jacketed projectiles. I am now turning my attention to Hardcast bullets. While general guidance is also welcome, I was specifically looking to load some...

I'm a newer firearms user who's read a lot without having done a lot, and I'm looking for advice from people who have some experience (read: actually know what they're doing) on a load I'd like to work up to be useable in both a carbine and an older revolver. I should also mention I'm up in...

I'm looking at a 25-06AI that I want to pick up, but haven't started reloading yet, and want some information on it. 1 what is there downside of using regular 25-06 ammo instead. Asking because I found a great deal on a large amount. 2 can you load rounds light as in 40-45gr of powder...

Hello all, I am looking into getting a cartridge conversion of a Uberti Colt 1851, and I have been wondering how powerful of a black powder cartridge I could use in the gun, and what I could feasibly make for it. I am hoping that maybe some of you others have already tried this out on your own...

After gathering all the reloading equipment and reading and lurking on different sites, it was time to get started. I have experience with C&B revolvers which led me to have a interest in loading my own cartridges. GP 100, 4 inch, .357. Bullseye powder, .38 -125 grain lead cast powder...