Hello all,
First of all, thanks so much to everyone on here for being an awesome community of reloaders. It’s been like having a reloading club next door but from all over the world!
Now on to my issue-
I recently purchased a Redding 2-die set for 30-06 to replace the Lee set I’ve been using...
I have a Dillion 550 RL press. I'm using a Lyman MSR die set. The size die is a small base die. I'm using One Shot spray sizing lube. I have New Never fired Starline brass. I had 5 cases rip out of the shell plate, and I'm not able to size them all the way down. I've tried sizing them in steps...
So, I’m reading up on bullet casting and I’m a little confused about something. Everything I read says cast bullets need to be sized before they can be used. Is that true even if they cast at the correct diameter? For example, if I buy a .459 diameter bullet mold and I want a .459 bullet do I...
Hey y'all, I just picked myself up an 1892 Ordnance Revolver, often called a Lebel revolver. I intend to handload for this pistol, and already have some loads I've researched as well as brass. I want to use cast bullets for their cost effectiveness, but the only 8mm cast bullets I can find are...
Good morning, everyone. I have a few questions pertaining to reloading for my WOA Varmint 223. I think I know the answer to the first two, but can't find the answer to the last one for the life of me. Any help is much appreciated.
1) I have some once fired brass from Mil-Spec (or close to it)...
For all of the rifle cals I reload I use a case gauge to help with sorting cases as to what needs to be done before reloading. This photos shows results after sizing .308 Win cases.
I have never loaded belted brass before, just -06 and handgun. My question is weather or not to full-length size or just neck size the brass. It will be fired in the same rifle it was fire-sized in. I want to measure for a good c.o.l. so I'm kinda leaning towards neck sizing only. Thoughts...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.