Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

.17 Mach IV

Discussion in 'Handloading and Reloading' started by Dave R, Dec 29, 2002.

Thread Status:
Not open for further replies.
  1. Dave R

    Dave R Member

    Joined:
    Dec 26, 2002
    Messages:
    3,628
    Location:
    Idaho
    I lost a close friend recently. His family gifted me one of his rifles. Its a .17 based on .357 mag pistol brass.

    I had a chance to visit my departed friend's house today to look for dies and load data.

    Sadly, he was not very organized. I found no load data. But I did find 2 dies. They were from RCBS, and they were labeled for .17 Mach IV. So that must be what its called.

    There was a single forming die (there must be more of 'em somewhere) and a trimming die. So here are some questions:

    1) Anyone know what the complete set of dies should include? I'm guessing:
    -Several forming dies to neck the .357 case down to .17.
    -A neck reamer
    -A full-case sizing die?
    -The trimming die which I have.
    -Any others?

    2) Anyone know where I can get load data for this? Is it in the commercial catalogs?

    3) Does anyone list the dies in their catalog, so I can purchase any dies I can't find? Even though the dies I found were RCBS, I couldn't find any mantion of .17 Mach IV on the RCBS website.
     
  2. Steven Mace

    Steven Mace Member

    Joined:
    Dec 24, 2002
    Messages:
    206
    Location:
    Peoria, AZ USA
    Dave, as has been posted in another thread the .17 Mach IV is based on the .221 Fireball case not the .357 Mag. case. At this point I would recommend contacting to people at Huntingtons to see if they're aware of such a wildcat caliber. They specialize in custom caliber reloading equipment. Hope this helps!

    Steve Mace
     
  3. Dave R

    Dave R Member

    Joined:
    Dec 26, 2002
    Messages:
    3,628
    Location:
    Idaho
    Thanks for setting me straight. The Mach IV die must've been a red herring. I thouht maybe it could be used, but the formed brass won't even fit in it.

    Oh, well.
     
  4. redneck2

    redneck2 Member

    Joined:
    Dec 25, 2002
    Messages:
    11,009
    Location:
    Northern Indiana
    IIRC...

    there was an article in Handloader maybe a year ago that talked about some of the various .17's

    http://www.saubier.com has a small caliber forum

    before you get too deep, you may want to make sure exactly what you have. Probably have to do a chamber casting. Need to find out from someone with more experience than me.
     
Thread Status:
Not open for further replies.

Share This Page