Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

1911 hammer & beavertail issues

Discussion in 'Handguns: Autoloaders' started by patkeltx, Jan 13, 2010.

Thread Status:
Not open for further replies.
  1. patkeltx

    patkeltx Member

    Joined:
    Dec 30, 2009
    Messages:
    26
    I recently purchased a Wilson commander hammer and beavertail. According to the techs @ Wilson the hammer is required for the beavertail installation. Frame modification for beavertail went very well. Looks good to. My issue comes in when I try to install the thumb Saftey. It will not clear the sear and hammer assembly. Any help would be greatly appreciated!
     
  2. Art Eatman

    Art Eatman Administrator Staff Member

    Joined:
    Dec 22, 2002
    Messages:
    43,850
    Location:
    Terlingua, TX; Thomasville,GA
    Post in only one forum, please. Don't do multiple posts on the same subject.
     
Thread Status:
Not open for further replies.

Share This Page