Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

22 Cal Mag Loader - Ruger Autos - Where?

Discussion in 'Handguns: Autoloaders' started by jjohnson, Feb 14, 2009.

Thread Status:
Not open for further replies.
  1. jjohnson

    jjohnson Member

    Joined:
    Oct 7, 2005
    Messages:
    1,181
    Location:
    Rochester, Minnesoviet
    Hi, gents!

    Hey, I've lost that two-bit little "mag loader" for my Ruger 22 auto pistols that I used for YEARS.:mad:

    What I'm looking for is a single plastic molding, one-piece, that just pulls the button down. I don't need anything with moving parts. The one I had just slipped around the mag - not a whole ring, but a split-rail job with a sort of claw cutout that moves that annoying little button down.

    Anybody got one they can recommend? I've seen the T-shaped ones that slip over the mag, and that's sort of close. I can't find the model I had...and of course since I LOST it I have no manufacturing stamp on it to refer to....

    So... what are YOU guys using? And who stocks 'em?

    Thanks - I always appreciate the advice.
     
    Last edited: Feb 14, 2009
  2. Milkmaster

    Milkmaster Member

    Joined:
    Dec 29, 2006
    Messages:
    2,027
    Location:
    Murfreesboro, TN
  3. Jolly Rogers

    Jolly Rogers Member

    Joined:
    Feb 19, 2008
    Messages:
    620
    Location:
    Northern Virginia
    +1 on the Ultimate Clip Loader. You won't miss the $$ .
    Joe
     
  4. RedAlert

    RedAlert Member

    Joined:
    Jul 27, 2006
    Messages:
    677
    Location:
    Silverdale, WA
    I just used a piece of aluminum angle. In one side drill a hole just larger than the button on the side of the mag. Use a round hole file to file a make the hole "key-hole" shaped so the button shaft will fit in it.

    Twenty minutes work and it works just fine. Cheap too.
     
Thread Status:
Not open for further replies.

Share This Page