1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

3 popular rimfire and red dot

Discussion in 'Handguns: General Discussion' started by dashootist, Aug 20, 2011.

Thread Status:
Not open for further replies.
  1. dashootist

    dashootist Member

    Feb 8, 2010
    If I install a red dot scope on these pistols, which ones require the red dot to be removed before field stripping and cleaning?

    (1) Ruger MK3
    (2) Buckmark
    (3) S&W 41
  2. Quadkid

    Quadkid Member

    Dec 20, 2008
    central CT
    i think only the Buckmark.

    The Ruger shouldnt need to remove the rail, and im not too sure about the 41.
  3. Steve C

    Steve C Member

    Jan 5, 2006
    On the Buckmark it depends upon which model pistol and which model red dot sight. On the models with the rail that runs the full length of the barrel you can leave the red dot installed and simply remove the rear screw and the front barrel screw and leave it attached with the barrel. With a basic model that you've simply replaced the top strap of the pistol with a rail it will depend upon the length of the red dot as to if you can access the attachment screws without removing it from the base but it is removed from the barrel and frame.
Thread Status:
Not open for further replies.

Share This Page