Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

629 Grips

Discussion in 'Handguns: Revolvers' started by TwoNiner, Mar 29, 2010.

Thread Status:
Not open for further replies.
  1. TwoNiner

    TwoNiner Member

    Joined:
    May 26, 2009
    Messages:
    172
    Trivia question here: What kind of grips were offered on the 629-1 3" 44 mag? Were they wood or pachmayrs? Its a square butt right? How about the 629-1 6" 44?
     
  2. BigBore

    BigBore Member

    Joined:
    Mar 21, 2010
    Messages:
    83
    Location:
    Kodiak AK
    Easy, both were wood unless specified different at the time of ordering the revolver....
    Finger grove round butt for 629-1 3 "

    And Checkered wood square butt for the 629-1 6"

    Oh and forgot to add, just about everybody makes grips for both the round and square ..Hogue , Pachmayr, Herrit and so on..Wood, Ivory,Stone inlay,Rubber..Great thing about owning S&W's everyone makes accessories for them..Its the holsters that are harder to find, mainly for the 3 inch..Galco, Desantis and G&G are some of the few..
     
  3. Oro

    Oro Member

    Joined:
    Sep 22, 2007
    Messages:
    3,496
    Location:
    WA state
    As BigBore said. If you are looking to buy a gun and they are missing the original wood grips, deduct $75 from the book or average going value for the gun if it's a 6", and $150 or more for the much more rare 3" Finger-groove type. Here's what they should look like:

    IMGP5381.jpg
     
Thread Status:
Not open for further replies.

Share This Page