Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

642 front sightoff center

Discussion in 'Handguns: Revolvers' started by CarlJ, Jun 13, 2012.

Thread Status:
Not open for further replies.
  1. CarlJ

    CarlJ Member

    Joined:
    Jul 16, 2009
    Messages:
    100
    Sitting here dry firing aiming into the computer screen I now noticed the front sight is off center of the ramp about 1/16". It seems the barrel needs to be rotated just slightly to correct this. Is this something a smith can do?
     
  2. 9mmepiphany

    9mmepiphany Moderator

    Joined:
    Dec 27, 2002
    Messages:
    18,922
    Location:
    northern california
    With the alloy frame, you'd likely be better off sending it back to the factory for the work
     
  3. owlhoot

    owlhoot Member

    Joined:
    Jun 10, 2005
    Messages:
    941
    If the gun shoots to point of aim, leave it alone and be happy. Fixed sight revolvers are sighted in by turning the barrels. It is not uncommon to find old model 10's with the sight off center for this reason. However, snubs are seldom sighted in this way. With a snub the procedure is to whack the barrel at the frame/yoke area with a heavy, soft lead rod and bend the frame a bit. I know that sounds extreme, but that's how it is done.

    Shoot your revolver from a rest. If you aren't an expert shot, find someone who is and have him shoot it from a rest. If the gun shoots to point of aim, be glad. If it doesn't, have a reputable smith turn the barrel so the sight lines up properly or send the gun back to the factory.
     
Thread Status:
Not open for further replies.

Share This Page