Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

9mm question

Discussion in 'Handloading and Reloading' started by ammopoor, Dec 29, 2007.

Thread Status:
Not open for further replies.
  1. ammopoor

    ammopoor Member

    Joined:
    Dec 25, 2007
    Messages:
    43
    I'm a newbie and will be getting my press this coming week. My question is when loading a bullet and the actual recipe cannot be found for specific components what is the general rule of thumb? I'm wanting to load a 9MM Magtech 124 grain FMJ with w231 in once fired brass using cci primers. I'm getting a speer 14th edition rloading book with the rest of my supplies are these books brand specific?
     
  2. The-Fly

    The-Fly Member

    Joined:
    Nov 1, 2005
    Messages:
    897
    Location:
    Northern Colorado
    While I am no expert, I wouldn't worry too much about the brand of primer your using, as long as its the right one (small pistol, non magnum). I do load 124gr 9mm with W231, so here's my load.

    124gr FMJ, 4.6gr of W231. Does about 1100fps out of my G34.

    This is a full powered load (but well with in limits, book max is 4.8gr). If you want something a bit more tame, drop it down to 4.4 or 4.2
     
Thread Status:
Not open for further replies.

Share This Page