Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Accurate 3100

Discussion in 'Handloading and Reloading' started by Big_R, Dec 28, 2005.

Thread Status:
Not open for further replies.
  1. Big_R

    Big_R Member

    Joined:
    Dec 27, 2002
    Messages:
    384
    Location:
    That little strip of land between New York and L.A
    I've been using AA 3100 for some rifle cartridges, and finally ran out. I bought a new can, and when openend, it smelled really bad (like toluene). Anyone know if the formula changed? It seems to work correctly (velocity, etc.).


    Ryan
     
  2. Oldnamvet

    Oldnamvet Member

    Joined:
    Jun 15, 2005
    Messages:
    1,675
    Location:
    Michigan
    If there is residual solvent, such as toluene, in the powder, be careful about putting it into your measure. It could start etching the plastic and damage your equipment.
    I would contact the manufacturer about it.
     
Thread Status:
Not open for further replies.

Share This Page