Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Advice for holster CC for Colt Mustang

Discussion in 'Handguns: Holsters and Accessories' started by Pancho, Jan 28, 2011.

Thread Status:
Not open for further replies.
  1. Pancho

    Pancho Member

    Joined:
    Oct 23, 2007
    Messages:
    1,874
    Location:
    Southwestern, Ohio out in the country about 40 mil
    I've tried this thread on the "Automatic forum" to no avail so I thought I'd try it here.
    My question is about the proper way to holster carry a single action automatic Colt Mustang.
    Assuming that the holster is a form fitted leather one that encloses the trigger.
    Assuming that there is a round in the chamber.
    Could you carry the gun safely with the hammer down?
    Could you trust the safety and carry the gun cocked?
     
  2. David E

    David E Member

    Joined:
    Aug 3, 2008
    Messages:
    7,455
    I would trust the safety and carry it in a KyTac holster that is molded to engage the safety, keeping it in the "on" position.

    www.kytac.com
     
  3. heeler

    heeler Member

    Joined:
    Dec 18, 2007
    Messages:
    2,619
    Pancho,I know Bianchi makes several holsters for the Mustang.
    For a few weeks I carried my Mustang PocketLite in a borrowed IWB holster that was made for the Mustang.
    I found the set up uncomfortable because of the rather sharp beavertail spur kept goughing me in the side.
    But more than that I carried the little pistol cocked with the safety on and found one day that somehow or another the safety had been pushed off to fire mode.
    That scared me so bad I have never carried the pistol like that again.
    If the Mustang had a grip safety like the 1911 that would have been no big deal but it does not so when the hammer is cocked the trigger action is very light on my Mustang and that could have been diasterous for me.
    For what ever reason the Colt owners manual does not recommend carrying the Mustang chambered with the hammer down.
    And even if that was safe dropping the hammer down on a chambered round could cause the pistol to discharge.
    Time for some of our more experienced carry hands to speak up on this issue.
     
  4. CDR_Glock

    CDR_Glock Member

    Joined:
    Jul 4, 2010
    Messages:
    577
    Location:
    Virginia
    Condition One, cocked and locked, ONLY. Do not depend upon any other way. If that hammer gets snagged and then it drops. Well....you get DaBloody idea!
     
  5. Pancho

    Pancho Member

    Joined:
    Oct 23, 2007
    Messages:
    1,874
    Location:
    Southwestern, Ohio out in the country about 40 mil
    Thank you gentlemen and thank goodness I finally found the right forum.
    As a revolver enthusiast I've always felt perfectly safe with the hammer down on an empty chamber or with the NAA type firearms between chambers "cock,lock,and rock".
    As I understand you so far This Mustang requires some trust and or careful choice in holsters.
     
  6. heeler

    heeler Member

    Joined:
    Dec 18, 2007
    Messages:
    2,619
    From my experience your last sentence is correct.
    I dont carry mine any longer.
     
  7. ssyoumans

    ssyoumans Member

    Joined:
    Jan 15, 2010
    Messages:
    701
    I carried mine for years, locked and cocked in a Don Hume JIT holster. Very compact, very comfortable, and affordable, around $25. Most of the gun shows around here sell them or you can pock them up off of ebay. I have also used the Uncle Mike's Inside the pants holster, but never found this as comfortable as the JIT hip holster.
    I have put the Colt Mustang away to the safe, but carry it's near clone, the SIG P238 in a JIT as well.
    Note, they are not the same JIT model. Sig slide just a little different.
     
  8. heeler

    heeler Member

    Joined:
    Dec 18, 2007
    Messages:
    2,619
    Is that Don Hume an IWB or a OWB holster??
    Ever had any issues with the safety being disengeged as I spoke of in my earlier post?
     
  9. Fred Fuller

    Fred Fuller Moderator Emeritus

    Joined:
    Mar 26, 2004
    Messages:
    21,220
    Location:
    AL, NC
    Let's see how it goes in Handgun Holsters...

    lpl
     
  10. Pancho

    Pancho Member

    Joined:
    Oct 23, 2007
    Messages:
    1,874
    Location:
    Southwestern, Ohio out in the country about 40 mil
    Lee,This hasn't gone very well at this thread
     
  11. ssyoumans

    ssyoumans Member

    Joined:
    Jan 15, 2010
    Messages:
    701
    The Don Hume is an OWB. No problems with safety. It doesn't cover or get near it. So unless your body is going to disengage it.
     
Thread Status:
Not open for further replies.

Share This Page