Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Ammo for new 442

Discussion in 'Handguns: Revolvers' started by Diggers, May 9, 2009.

Thread Status:
Not open for further replies.
  1. Diggers

    Diggers Member

    Joined:
    Sep 10, 2007
    Messages:
    890
    Hi all, thought I would beat this dead horse some more. ;)

    Any opinions here of magtech ammo? I like the 158 semi jacket hp for use in my soon to have 442. Good match? Too subjective to say?

    This is the +p version of this ammo there is also a non+P (funny their site doesn't note the difference.)

    http://www.magtechammunition.com/si...tails&templateId=14&pageId=103&search=details

    Whats nice about it is less expensive then say federal or winchesters swc 158 grain HP.

    midway, when they have ammo again, sells it for 22 bucks.

    Last thing, I went to winchester, remington, and federal and could not find any 158 grain HPs listed.......am I looking at the wrong page or are they not making this ammo any longer?

    Thanks for the input.

    OH never mind I found winchester and remingtons 158 HP ammo.....:eek:
     
    Last edited: May 9, 2009
  2. rklessdriver

    rklessdriver Member

    Joined:
    Mar 12, 2008
    Messages:
    926
    Location:
    NOVA
    I like a heavy bullet in the 38 and carry the Remington +P 158gr LHP (as in LEAD Hollow Point). It is AKA the "FBI load". The recoil out of an Airweight J frame is pretty stout.

    Remington is the only 158gr bullet that will expand out of a snubbie. Federal and Winchester also offer a version of this LHP load but the slugs are too hard of a lead. Any 158gr SJHP is going to be very iffy on expansion.

    Other than the Remington load, Speer offers the 135gr Gold Dot "short barrel" load will do a good job out of your 442.
    Will
     
  3. Diggers

    Diggers Member

    Joined:
    Sep 10, 2007
    Messages:
    890
    Thanks for the info. I'm not too worried about recoil, Im used to my .44 mag so I'll deal. I know this isn't a range gun.

    I shot a M&P 340 with Fiocchi 130 grain ammo a while back.. Fiocchi doesn't say its +P, but it would if it was made by an American company. Its moving around 940ish FPS and did have a little bite to its recoil in that 12 oz gun but its not anything to write home about.

    I'll try a little of both +P and non +P just to see.......if I can find some any place. :(

    I really like heavy bullets better but Buffalo Bore makes a nice non +P (they say :) )125 grain JHP that opens up well in gel tests and penetrates well too.

    It will be fun trying out different loads. :)
     
  4. ArchAngelCD

    ArchAngelCD Member

    Joined:
    Nov 25, 2006
    Messages:
    21,670
    Location:
    Northeast PA, USA
    I carry the "FBI Load" in my J frames, the Remington R38S12 ammo to be exact. (158gr LSWC/HP +P) Buffalo Bore ammo has a good reputation but at ~$30/20 rounds it's hard to afford practice with it. Last time I bought the Remington ammo it was $32/50 rounds. Still not cheap but nowhere near as bad as Buffalo Bore, Speer, CorBon and the other ammo "we just can't do without."

    If you want a JHP bullet instead of Lead take a look at the 125gr .38 Special +P ammo from DoubleTap. I've shot it in my Airweight and it's accurate and controllable. (I still like the FBI Load better!! LOL)
     
  5. thesecond

    thesecond Member

    Joined:
    Jan 3, 2008
    Messages:
    136
    Location:
    Las Vegas, NV
    Buffalo Bore. 158 grain SWHC.
     
  6. KBintheSLC

    KBintheSLC Member

    Joined:
    Jul 30, 2007
    Messages:
    3,197
    Location:
    Stalingrad, USA
    I'm using S&B 158g JSP in my new S&W 637... good hard hitting stuff... standard pressure.
     
  7. Diggers

    Diggers Member

    Joined:
    Sep 10, 2007
    Messages:
    890
    ArchAngelCD,

    I agree with you on the price of these special SD ammo, good stuff but sheesh. :eek:

    The remington ammo will most likely be the stuff I use. Have you had any issues with leading in your gun?
     
  8. rklessdriver

    rklessdriver Member

    Joined:
    Mar 12, 2008
    Messages:
    926
    Location:
    NOVA
    It leads a bit in my Smith 36 and my Colt Cobra but it's nothing chore boy and a little Hoppes can't take care of.
    Will
     
  9. Gardien

    Gardien Member

    Joined:
    Feb 22, 2009
    Messages:
    61
    Location:
    In the Rockies
    I carry Speer Gold Dot 135 gr +P in my 642. Have also carried BB 158 gr LSWCHP +P.

    BTW-Stay away from Remington UMC +P for range ammo. Had a lot of FTFs, but Remington is taking them back.
     
  10. ArchAngelCD

    ArchAngelCD Member

    Joined:
    Nov 25, 2006
    Messages:
    21,670
    Location:
    Northeast PA, USA
    No real leading to speak of. I usually clean my revolver as usual after a range trip without any special attention because lead. What little does get left behind is removed during the normal cleaning. (Hoppe's #9)
     
  11. 9mmepiphany

    9mmepiphany Moderator

    Joined:
    Dec 27, 2002
    Messages:
    18,495
    Location:
    northern california
    if you want to use the 158gr slug...go with the all lead SWC-HP

    i converted to the short barrel specific load, for my 642, a couple of years ago...Speer Gold Dot 135gr
     
  12. flyingdeserteagle

    flyingdeserteagle Member

    Joined:
    Apr 24, 2009
    Messages:
    40
    Location:
    San Diego, CA
    Is the 135 Gold Dot a +P load ?
     
  13. Gary A

    Gary A Member

    Joined:
    Dec 28, 2002
    Messages:
    1,474
    Yes, it is. From Speer's Technical Data Package on the round:

    Product Maximum Average Pressure
    38 Special +P 21,500 psi
     
  14. wnycollector

    wnycollector Member

    Joined:
    Dec 10, 2006
    Messages:
    3,114
    Location:
    Western NY
    I chronographed magtech's standard pressure SJHP loading in two of my revolvers. Magtech claims 807 FPS for this loading, but it never broke 700fps (694fps average) in my model 36 snub. Out of my 5" K frame it averages 733fps. For comparison mastercasts 158gr SWC averages 869 in the K frame and 770 in the J frame.

    The remington FBI load (158gr +P LHP) has been around for half a century because IT WORKS! I carry that load in ALL of my .38's.
     
  15. Diggers

    Diggers Member

    Joined:
    Sep 10, 2007
    Messages:
    890
    wnycollector

    Thanks for that important bit of info. Good to know. That pretty much rules magtech ammo out for any thing other than the range.

    The maker always seems to give a higher PFS than what the ammo does in real life, but that much less is too much.
     
  16. wnycollector

    wnycollector Member

    Joined:
    Dec 10, 2006
    Messages:
    3,114
    Location:
    Western NY
    If we are talking .38 ammo from magtech, I agree that its range only. I have chronoed their 155gr .40 JHP and their guardian gold +P .45 230gr JHP and the ammo was within 30-40fps of the magtech claims.
     
  17. David E

    David E Member

    Joined:
    Aug 3, 2008
    Messages:
    7,455
    The 442 has an enclosed hammer. If you get open-backed grips, you can get an unusually high hold on the gun, which negates much of the torque generated by the stouter loads. It still kicks, but it comes straighter back into the hand/arm resulting in less muzzle flip.
     
  18. kmrcstintn

    kmrcstintn Member

    Joined:
    Jan 5, 2006
    Messages:
    1,235
    Remington 'FBI' load (158gr lswchp +p) or Speer 'short barrel' Gold Dot (135gr jhp +p);

    if you opt for the Remington leadhead, you'll need to spend a bit more time cleaning your gun to remove lead fouling
     
  19. watchtower7

    watchtower7 Member

    Joined:
    Feb 14, 2008
    Messages:
    30
    Its been awhile since I was here, the 642 is out of stock but the 442 is ready to go.
    Just a finish difference?
     
  20. 9mmepiphany

    9mmepiphany Moderator

    Joined:
    Dec 27, 2002
    Messages:
    18,495
    Location:
    northern california
    exactly, just a finish difference
     
  21. P. Plainsman

    P. Plainsman Member

    Joined:
    Jun 22, 2004
    Messages:
    1,125
    Location:
    Red America
    My reading and shooting have led me to the same place as a lot of other folks on this thread: I carry the Remington 158 gr LSWCHP .38+P (Item No. R38S12) in my 642. For a reload I carry a speed strip or speedloader of the Speer 135 grain Gold Dot JHP .38+Ps.

    The 135 grain Gold Dots are very hard to find right now. I've stopped shooting them in practice until availability improves. The Remingtons are a little easier to find, though you must still keep an eye peeled.

    I would also consider Buffalo Bore's STANDARD pressure 158 grain lead HP .38 for your gun. (I love the Buff Bore 158 gr lead .38+P in a steel Ruger SP101 but that +P load is just too feisty for me to shoot well in an airweight J-frame.)
     
  22. gwillis6

    gwillis6 Member

    Joined:
    Apr 28, 2008
    Messages:
    37
    Location:
    Alabama, USA
    Remington 158 grain LSWCHP "FBI Load"
     
  23. gringolet

    gringolet Member

    Joined:
    May 9, 2005
    Messages:
    242
    good

    a good load for the 442 ( I carry a 442 regularly)...
    is the
    buffalo bore 150 Gr. wadcutter...
    the corbon dpx 110 gr h
    ...I am
    not a big fan of the 158 gr plus p in an airweight
    snubby simply because it hurts to shoot the thing!
    and that is not helpful for my accuracy...either of the
    above carry plenty of pop, penetrate well, and will
    be easier to manage well than the
    BIG bullets some suggest...AND, I'd recommend
    you consider porting for your revolver...think I am
    going to port all of mine...and get the TK custom moonclip
    coversion while you are at it...check with gemini custom,
    pinnacle guns, etc.
     
  24. Diggers

    Diggers Member

    Joined:
    Sep 10, 2007
    Messages:
    890
    Picked up my gun, 442-1, a few days ago and shot it yesterday for the first time. :)

    What a great little revolver!!. I shot a box of 130 grain non+P and 10 rounds of Rem 125 grain JHP +P ammo. The difference was obvious but not really a big deal at all.

    Good Stuff!! :D
     
Thread Status:
Not open for further replies.

Share This Page