Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

...and so the madness begins...

Discussion in 'Rifle Country' started by sid_666, Dec 15, 2009.

Thread Status:
Not open for further replies.
  1. sid_666

    sid_666 Member

    Joined:
    Oct 6, 2009
    Messages:
    13
    Location:
    Calgary, Alberta Canada
    New project, AR-15 carbine based on RRA lower. Parts sourced from both Canada and the U.S.A. RRA Left.jpg
     
  2. dakotasin

    dakotasin Member

    Joined:
    Dec 26, 2002
    Messages:
    4,777
    Location:
    Transient
    enjoy!
    good luck!
     
  3. Quentin

    Quentin Member

    Joined:
    Jul 30, 2005
    Messages:
    1,826
    Location:
    NorthWest USA
    Yes, good luck! I just did my first build three months ago and fondly remember the day I brought home the stripped lower.
     
  4. WhoKnowsWho

    WhoKnowsWho Member

    Joined:
    Dec 25, 2002
    Messages:
    3,432
    Location:
    Maricopa, AZ
    It looks so benign sitting there... but in a short while it will be sucking up the money in more ways than one!
     
  5. sid_666

    sid_666 Member

    Joined:
    Oct 6, 2009
    Messages:
    13
    Location:
    Calgary, Alberta Canada
    ..."The postman rings twice"...
     

    Attached Files:

  6. sid_666

    sid_666 Member

    Joined:
    Oct 6, 2009
    Messages:
    13
    Location:
    Calgary, Alberta Canada
    A few more parts bcg, receiver extension tube (ordered wrong one - comm. spec. instead of mil. spec.) 20" RRA 1 in 9 twist Wylde chambered.
     

    Attached Files:

Thread Status:
Not open for further replies.

Share This Page