Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Another Walther question

Discussion in 'Gunsmithing and Repairs' started by cliffdropover1, May 27, 2003.

Thread Status:
Not open for further replies.
  1. cliffdropover1

    cliffdropover1 Member

    Joined:
    Feb 4, 2003
    Messages:
    28
    I noticed in a list of Walther parts, that the firing pin for the Walther PP and PPK can be either round or flat. About when was a change made and are the firing pins for the PP and PPK the same length? Any help is greatly appreciated.
     
  2. dfariswheel

    dfariswheel Member

    Joined:
    Dec 26, 2002
    Messages:
    6,121
    I believe the change was made beginning with the new post-war guns. Up until 1945 the pin was flat, after the war, Walther did a slight re-design of the P-38 and the PP series.

    The PP's pin was changed at that time.
     
  3. cliffdropover1

    cliffdropover1 Member

    Joined:
    Feb 4, 2003
    Messages:
    28
    Thanks for the help.:)
     
Thread Status:
Not open for further replies.

Share This Page