Anyone have an LCRx?

Discussion in 'Handguns: Revolvers' started by Triggernosis, Jan 16, 2018.

Thread Status:
Not open for further replies.
  1. Triggernosis

    Triggernosis Member

    Joined:
    Jan 11, 2010
    Messages:
    455
    If one of you would be so kind as to provide me with a measurement, please, I would greatly appreciate it. I am making holster for a customer's LCRx and I only have a mold for the LCR. I intend to cut off a little piece of the backstrap from my LCR mold to match the LCRx, which has a less pronounced "hump". The attached picture shows the place I need the measurement for.
    Thanks in advance.
     

    Attached Files:

  2. webrx
    • Contributing Member

    webrx Contributing Member

    Joined:
    Nov 10, 2010
    Messages:
    1,112
    Location:
    Reno
    I measure it at 1.77 inches

    Dave
     
  3. Triggernosis

    Triggernosis Member

    Joined:
    Jan 11, 2010
    Messages:
    455
    Thanks a bunch, Dave. Much appreciated.
     
  4. Triggernosis

    Triggernosis Member

    Joined:
    Jan 11, 2010
    Messages:
    455
    Well, thanks to Dave's measurements, here's the crossdraw thumb break holster I created for my customer. It fits perfectly - and also fits an S&W model 60.
     

    Attached Files:

    chicharrones and BeornLS like this.
  5. BeornLS

    BeornLS Member

    Joined:
    Nov 9, 2005
    Messages:
    32
    Location:
    Houston TX
    Nice work sir!
     
    Triggernosis likes this.
Thread Status:
Not open for further replies.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice