Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Anyone here own a T/C Seneca ? Need stock info.

Discussion in 'Blackpowder' started by BADUNAME30, Nov 15, 2012.

Thread Status:
Not open for further replies.
  1. BADUNAME30

    BADUNAME30 Member

    Joined:
    Mar 24, 2009
    Messages:
    1,876
    Location:
    Neshannock, Pa.
    This is the forend of a T/C Seneca stock i'm thinkin o' buyin.
    Is this nose gaurd screw hole 'blown' thru ?

    IMGP1851.JPG
    IMGP1852.JPG
     
  2. Curator

    Curator Member

    Joined:
    Apr 20, 2007
    Messages:
    1,205
    Location:
    Bonita Springs, Florida
    Jim,

    Your forearm seems correct. The large hole nearest the end is for a large-headed screw that retains the forearm cap. The smaller hole to the rear of the other is for the screw that retains the ramrod entry-pipe. If you can find an "exploded view" online somewhere it will become obvious.
     
  3. BADUNAME30

    BADUNAME30 Member

    Joined:
    Mar 24, 2009
    Messages:
    1,876
    Location:
    Neshannock, Pa.
  4. Curator

    Curator Member

    Joined:
    Apr 20, 2007
    Messages:
    1,205
    Location:
    Bonita Springs, Florida
    Jim,

    The forward hole on my two Senecas have a large (7/16) flat-head screw that goes into the nose cap. The rear screw is much smaller (1/4") head. The nose caps/entry pipes on my Senecas do look slightly different than the one on Ebay. That may be one form a Patriot pistol. I am not sure if they are interchangeable with the Seneca rifle.
     
  5. BADUNAME30

    BADUNAME30 Member

    Joined:
    Mar 24, 2009
    Messages:
    1,876
    Location:
    Neshannock, Pa.
    Thanx Curator, i'm learnin that i don't yet know enough about this gun to attempt this build.
     
Thread Status:
Not open for further replies.

Share This Page