Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

AR-15 lower receiver assembly instructions

Discussion in 'Rifle Country' started by goalie, Dec 1, 2003.

Thread Status:
Not open for further replies.
  1. goalie

    goalie Member

    Joined:
    May 1, 2003
    Messages:
    1,168
    Location:
    Minnetonka, Minnesota
    Does anyone have a good link to instructions for assembly of a stripped lower receiver with a parts kit? I had planned on using the instructions on www.ar15.com but the site seems to be down, and the UPS guy will be here with my parts kit within an hour or so. Thanks in advance.

    :)
     
  2. uglymofo

    uglymofo Member

    Joined:
    Jan 4, 2003
    Messages:
    429
    Location:
    PRK
    Yeah, but if you plan ahead, you've copied AR15's entire set of instructions to your hard drive and stored it in MS Word, like me....;)

    PM me your email, and I'll ship you a copy. I get your first-born when s/he's old enough to cut grass:D .
     
  3. goalie

    goalie Member

    Joined:
    May 1, 2003
    Messages:
    1,168
    Location:
    Minnetonka, Minnesota
    I sent you the e-mail. Thanks again, you know the old saying: "piss poor planning on your part does NOT constitute an emergency on MY part." Your help in resolving my self-inflicted emergency is much appreciated.

    As Homer Simpson would say: "DOH!!!"

    :D
     
  4. uglymofo

    uglymofo Member

    Joined:
    Jan 4, 2003
    Messages:
    429
    Location:
    PRK
    Incoming! I just sent it.
     
  5. goalie

    goalie Member

    Joined:
    May 1, 2003
    Messages:
    1,168
    Location:
    Minnetonka, Minnesota
    Thanks, it took all of 40 minutes to assemble the lower, and that was taking my time. I am really glad I had read other people's posts and taped the receiver. Buying the roll pin punches and pivot pin installation tool was also a good idea IMO.
     
  6. WhoKnowsWho

    WhoKnowsWho Member

    Joined:
    Dec 25, 2002
    Messages:
    3,432
    Location:
    Maricopa, AZ
    I got lucky, I didn't tape... :D

    Have fun with that AR, when you first pull the trigger and it goes bang, relief and excitement go through you all at once!
     
  7. uglymofo

    uglymofo Member

    Joined:
    Jan 4, 2003
    Messages:
    429
    Location:
    PRK
    Wellll, the good news is, I have a set of instructions that work:scrutiny: :D .

    I guess I'll save them for my own build. :D :D
     
  8. El Rojo

    El Rojo Member

    Joined:
    Dec 27, 2002
    Messages:
    2,541
    Location:
    The People's Republik of **********
Thread Status:
Not open for further replies.

Share This Page