AR15 trigger problems

Status
Not open for further replies.

CGRifleman

Member
Joined
Jul 16, 2010
Messages
221
A friend of mine installed a Rock River Arms 2-stage trigger in his Sig M400. He claims the selector lever does not allow the clearance for the sear to disengage, so the gun won't fire. Has anyone else experienced these problems with aftermarket triggers in the Sig? How can it be remedied?
 
Yes, that is what I meant. I was thinking mechanically. Sorry for the confusion.
 
I had a similar problem with a Rock River 2-stage that a friend bought but never installed. I sent it back to them with a note and had a new one in about a week.
 
It's a Sig Sauer M400 lower and safety, for reference. The RRA trigger is actually a few years old and has been in and out of a couple lowers, so a warranty is doubtful, but it had worked flawlessly for hundreds of rounds in the rifle it was in before this one. I found a spare RRA selector switch I forgot I had, so we'll swap it out with the Sig one and see if that works.
Thank you all for your help!
 
This is not a uncommon problem. Two solutions, mod the safety selector to fit, or mod the trigger to fit. Safety selectors are $8, the RRA trigger is $80, choose wisely.
 
The problem I've had with RRA NM triggers is that they have all eventually gone south on the disconnector-trigger interface. I've been OK with it as I see them as a relatively temporary installation and love the performance while it works.

I usually get one life extension outa them by addressing the interface but let 'em go after that. The cost of them relative to good ammunition and given what life I do get outa them makes them a worthwhile though by no means a permanent fit for me.
 
Status
Not open for further replies.
Back
Top