Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Argh!! Stuck 223 Case

Discussion in 'Handloading and Reloading' started by cwbys4evr, Apr 18, 2013.

Thread Status:
Not open for further replies.
  1. cwbys4evr

    cwbys4evr Member

    Joined:
    Mar 20, 2013
    Messages:
    153
    Why did I get a language infraction for my last post ??

    Sent from my PC36100 using Tapatalk 2
     
  2. Mobuck

    Mobuck member

    Joined:
    May 25, 2012
    Messages:
    285
    You would be well advised to run the cases through a sizing operation on a single stage press prior to running through the LEE 1000 press. As you have found, there's nothing holding the shell plate to the ram other than a small clamp. After a few of these episodes you'll either overtighten the clamp and break it or it simply won't clamp tightly at all. I've had the shell plate pull off while loading handgun cases so am not surprised this happened with .223 cases.
     
Thread Status:
Not open for further replies.

Share This Page