Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

auto case pro

Discussion in 'Handloading and Reloading' started by jmorris, Jan 19, 2010.

Thread Status:
Not open for further replies.
  1. jmorris

    jmorris Member

    Joined:
    Sep 30, 2005
    Messages:
    9,832
    I finally got to work on the automation of the cacepro to resize the rim of cases.


    DSC02028-1.jpg


    I welded a little tab, onto the set collars that I used as a clutch off of the drive motor, to keep them located properly when they slip (different calibers take different torques).

    DSC02024.jpg



    I also had a counter I purchased at a local surplus store I mounted so I know how many cases have been sized.


    DSC02025.jpg



    I made a pass through the base plate out of box tubing and used the same basket that I use for my auto annealer to catch them.



    DSC02027.jpg




    And the videos are here


    http://s121.photobucket.com/albums/...ding/casepro/?action=view&current=casepro.flv
    http://s121.photobucket.com/albums/...ing/casepro/?action=view&current=casepro1.flv
     
Thread Status:
Not open for further replies.

Share This Page