AutoMag II Fails to Extract

Status
Not open for further replies.
Uhhh... Don't have one here to look at. As best I recall, the chamber was dimpled inside. So a through scouring of the chamber with a brass brush and aggressive solvent might help. Brass/copper solvent sort of thing. Also a general purpose soot remover.

But I may be overlooking the obvious. Inspect the extractor. Those guns are, to keep this on the high road, not exactly strangers to parts failure.

More info: http://www.gunblast.com/Paco_22AutoMag.htm

Good luck.
 
Yea I have one, the chamber is a very strange sort of fluted, clean the heck out of it and shine a light in and you'll see what we're referring to, keep those clean and it should help a lot
 
Status
Not open for further replies.
Back
Top