Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Ballistic or primer mark?

Discussion in 'General Gun Discussions' started by vega, Apr 25, 2005.

Thread Status:
Not open for further replies.
  1. vega

    vega Member

    Joined:
    Dec 14, 2003
    Messages:
    228
    Location:
    SoCal
    Hi guys,

    Have anyone here seen this kind of mark before on a primer? It's either marked on the breech face or factory marked by the primer manufacturer.

    I was at the local firing range yesterday and I was collecting brasses for my 9mm (I know I'm cheap) and I don't really care if its my brass or not as long as I fill up my case. I shot 400 rds so I picked up the same quantity.

    [​IMG][/IMG]
    vega
     
  2. vmi93

    vmi93 Member

    Joined:
    Apr 16, 2003
    Messages:
    163
    Location:
    VA
    Glock?

    It looks like the striker mark left from the rectangular striker on a Glock. Glocks don't have round firing pins like most other pistols, they have a narrow rectangular striker that leaves a distinctive rectangular dent in the primer.
     
  3. model 649

    model 649 Member

    Joined:
    Mar 16, 2005
    Messages:
    540
    Are you talking about that mark that looks like the letter "A" on the lower area of the primer? That is weird. Looks like a way off-center strike, too. Never seen a primer marked with a letter before. Maybe it was, in fact on the breech-face and embossed the primer? Hmmmmm!
    Josh
     
  4. Preacherman

    Preacherman Member

    Joined:
    Dec 20, 2002
    Messages:
    13,309
    Location:
    Louisiana, USA
    I've seen primers with identifying letters or numbers on them, usually in ammo from some European countries, and typically in service-issue ammo. However, I've never seen any in the USA. Perhaps an imported batch?
     
  5. win71

    win71 Member

    Joined:
    Feb 8, 2005
    Messages:
    678
    R P Headstamp ??

    Looks like an RP case. Did you find anymore like this? Could be an odd one that got through. Didn't know about letter markings on foreign made stuff. Thanks Preacherman for that bit of wisdom!!
    Ron
     
  6. stevelyn

    stevelyn Member

    Joined:
    Mar 9, 2003
    Messages:
    3,290
    Location:
    Fairbanksan in Aleutian Hell
    I've noticed in newer lots of CCI Blazer and Speer Gold Dots that they have a 'V' stamped on the primer. I have no clue as to what its purpose is.
     
  7. vega

    vega Member

    Joined:
    Dec 14, 2003
    Messages:
    228
    Location:
    SoCal
    Yes, I was refering to the letter "A". If the letter is in the breech face then it would cause friction in the cycling since it would be slightly higher than the breech face. That is the only one I have and I didn't de-prime it. Wonder what A meant?

    vega
     
  8. Intel6

    Intel6 Member

    Joined:
    Feb 7, 2003
    Messages:
    66
    Location:
    SouthEast AZ
    Some manufacturers do mark their primers like that. I know CCI marks their match rifle primers with a little "B".

    Since this is a 9mm case I would guess that the round was probably a "lead free" round. A lot of the Lead that you can get from firing regular ammunition is actually from the lead styphenate in the primer. The key component to "lead Free" ammo is a lead free primer. When the ammo is loaded it is hard to tell the difference in the ammo if it is out of the box so they probably mark the primer so they know.

    Neal in AZ
     
  9. BluesBear

    BluesBear member

    Joined:
    Jul 25, 2003
    Messages:
    7,672
    Location:
    The Great Pacific NorthWet
    Neal beat me to it.

    I have noticed similat markings on "green" ammo recently. Since most, but not all, of the factory loads are also identified as such on the headstamp, marking the primer signifies that it is a factory loaded "green" primer and not a remanufactured round with a standard primer.
     
Thread Status:
Not open for further replies.

Share This Page