Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Belgium Frontier Army - Need info

Discussion in 'Handguns: Revolvers' started by TFLeader, Jan 26, 2011.

Thread Status:
Not open for further replies.
  1. TFLeader

    TFLeader Member

    Joined:
    May 30, 2010
    Messages:
    9
    Location:
    NE Mass
    Picked up a Frontier Army (44 WCF) project gun. Needs all new springs and a few small parts. Anyone have a source for parts? Also could use an exploded view.
     
    Last edited: Jan 26, 2011
  2. Jim K

    Jim K Member

    Joined:
    Dec 31, 2002
    Messages:
    17,752
    If it is an SAA clone, SAA or clone parts might fit or can be fitted. If not, can you post a picture of just what you have.

    Jim
     
  3. TFLeader

    TFLeader Member

    Joined:
    May 30, 2010
    Messages:
    9
    Location:
    NE Mass
  4. Jim K

    Jim K Member

    Joined:
    Dec 31, 2002
    Messages:
    17,752
    I don't have one of those, but have several of the smaller versions, in both CF and pinfire. I doubt you will find any parts anywhere for that gun. The springs will be mostly forged V springs with some forged flat springs. They can be made and fitted by any competent gunsmith, but if several are needed I can almost guarantee that the cost will exceed the value of the gun, assuming the $500 figure is about right for yours (and it seems right for the gun being sold).

    Jim
     
Thread Status:
Not open for further replies.

Share This Page