Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Bersa magazine carrier?

Discussion in 'Handguns: Autoloaders' started by HardCOR, Jan 14, 2004.

Thread Status:
Not open for further replies.
  1. HardCOR

    HardCOR Member

    Joined:
    Nov 17, 2003
    Messages:
    37
    Location:
    **********
    I haven't run across any mag carriers that are specificly made for Bersa
    Thunder 380 mags. What have other Bersa owners found to work well?
     
  2. horge

    horge Member

    Joined:
    Aug 23, 2003
    Messages:
    1,132
    Location:
    Philippines
    Do you mean mag pouches for a belt, HardCOR?
    (Terms change from one country to the next...)

    EDIT: Hah! "mag carriers" are indeed what i understood to be 'mag pouches', based on the pretty li'l thangs I saw over at Sidearmor.

    9mm is only a a wee bit longer than .380, so some users here just buy cheap 9mm Parabellum pouches (typically for double stack mags, so they're loose), then DIY shims of foam rubber, gluing each into every pocket to provide a snug fit. The 9mm belt-pouches typically come in 3-pocket config.

    Me? I'm forming one from scratch out of stiff plastic.
    If it works out, I'll post the results to THR :D
     
  3. HardCOR

    HardCOR Member

    Joined:
    Nov 17, 2003
    Messages:
    37
    Location:
    **********
    Yes, I meant magazine pouches. I'm thinking that ones for Walther PPK's should work. Bianchi makes an IWB version thalooks promising, but pricey to order and find it doesn't fit.
     
Thread Status:
Not open for further replies.

Share This Page