Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Burris Zee Ring Insert?

Discussion in 'Rifle Country' started by David Sours, Dec 10, 2009.

Thread Status:
Not open for further replies.
  1. David Sours

    David Sours Member

    Joined:
    Oct 15, 2009
    Messages:
    67
    Ok, got the new scope today along with my Burris Zee Rings. The 30 mm rings came with one set of 0 Inserts and 1 set of 10 Inserts Two +10 and two -10. So this is how I installed the scope and rings with the hope to get 20 MOA. Please tell me if I am wrong. In the scope ring @ the rear I put the +10 at the bottom and the -10 at the top per the directions. Then on the front ring I put the -10 on the bottom and the +10 on the top. Is this correct and am I right in thinking that I will get an additional 20 MOA in elevation?

    If so when I bore sight the rifle should I have to move the elevation of the scope down, to get the zero?

    Thanks,
    David
     
  2. browningguy

    browningguy Member

    Joined:
    Jul 21, 2004
    Messages:
    4,527
    Location:
    Houston, TX
    You are correct, as to which way to adjust, no way to know that until you give it a try.
     
  3. David Sours

    David Sours Member

    Joined:
    Oct 15, 2009
    Messages:
    67
    Thanks for the confirmation. Hopefully the wind will lie a little and I am headed to the range tomorrow to zero it in. Then we will know for sure.

    Thanks,
    David
     
Thread Status:
Not open for further replies.

Share This Page