Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Bushmaster .308 A2 Reassembly

Discussion in 'Rifle Country' started by afsnco, Mar 15, 2006.

Thread Status:
Not open for further replies.
  1. afsnco

    afsnco Member

    Joined:
    Mar 7, 2006
    Messages:
    59
    I'm having a problem with my rifle in the reassembly process. I emailed Bushmaster last week with this question, but they haven't responded yet.

    When tearing the weapon down for cleaning, I also removed the ejector pin and ejector, just as I was taught to do on active duty. When I attempted to reassemble it, however, this redesigned bolt requires that it be pressed down and in with a great deal of pressure. The spring is no longer straight up and down, but angled downward inside the bolt body. I was finally able to reassemble it only after getting a buddy to help.

    Has anyone else had this problem reassembling their Bushmaster .308? Am I missing some kind of tip or trick to make this go more smoothly? :confused:
     
Thread Status:
Not open for further replies.

Share This Page