Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Can you use a factory caliber change kit on a sig P226 NR

Discussion in 'Handguns: Autoloaders' started by FIVETWOSEVEN, Jan 13, 2010.

Thread Status:
Not open for further replies.
  1. FIVETWOSEVEN

    FIVETWOSEVEN Member

    Joined:
    Aug 28, 2009
    Messages:
    5,076
    I'm thinking about getting a Sig P226 from J&G and i would like to know if the
    .22lr and the .40 S&W caliber change kits will work with it.
     
  2. 9mmepiphany

    9mmepiphany Moderator

    Joined:
    Dec 27, 2002
    Messages:
    18,922
    Location:
    northern california
    the .22lr kit most likely will, depending on the frame of the model you get

    the .40 won't, you can only go from a larger calibre down, you can't go up on any 226
     
  3. FIVETWOSEVEN

    FIVETWOSEVEN Member

    Joined:
    Aug 28, 2009
    Messages:
    5,076
    i thought the 9mm and the 40 had the same frame. and its a 9mm non railed frame that i'm looking at.
     
  4. rellascout

    rellascout member

    Joined:
    Dec 22, 2004
    Messages:
    5,149
    Location:
    VA
    No the 9mm will not take a 40 S&W conversion.

    You can take a 40 S&W and swap the barrel with a .357 Sig. You can then get a barsto conversion barrel and make a 40 S&W or .357 Sig a 9mm.

    I believe the 22L conversions only work on newer guns.

    NOTE: May not properly fit older West German P226 models with serial numbers starting with U0 or U1
     
Thread Status:
Not open for further replies.

Share This Page