Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Can't Get FAB Defense/Mako Handguard on Vz.58/CZ858

Discussion in 'Rifle Country' started by stevehgraham, Mar 22, 2010.

Thread Status:
Not open for further replies.
  1. stevehgraham

    stevehgraham Member

    Joined:
    Jan 31, 2008
    Messages:
    43
    I have a Vz.58 folder from Czech-Point. I'm trying to put a FAB Defense handguard on it. I managed to remove the weird wood and plastic furniture, but the new handguard is too long to fit between the lower handguard loop and the receiver.

    It would fit fine if it were magically transported into place, but you have to mount the front end and then swing the back end up, and it's obstructed by the receiver.

    HELP!
     
  2. armoredman

    armoredman Member

    Joined:
    Nov 19, 2003
    Messages:
    16,213
    Location:
    proud to be in AZ
    You have to tap it in. PITA, but it will never move again. :) Is it this one?

    [​IMG]
     
  3. stevehgraham

    stevehgraham Member

    Joined:
    Jan 31, 2008
    Messages:
    43
    That's it. Dan at Czech-Point told me to beat it into place, so I did. It works better if you Dremel out the excess material FAB should not have put on the piece.
     
Thread Status:
Not open for further replies.

Share This Page