Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

CDNN scope: UTC 1-4X 28MM?

Discussion in 'Shooting Gear and Storage' started by dogsoldier0513, Sep 6, 2010.

Thread Status:
Not open for further replies.
  1. dogsoldier0513

    dogsoldier0513 Member

    Joined:
    Oct 21, 2006
    Messages:
    296
    Location:
    Heart of Dixie!
    CDNN scope: UTG 1-4X 28MM?

    Has anyone actually TRIED one of these? Any personal experience is appreciated. TIA
     
    Last edited: Sep 7, 2010
  2. wally

    wally Member

    Joined:
    Jan 2, 2004
    Messages:
    12,750
    Location:
    Houston, Tx
    Assuming you mean UTG, I've got one and while its no Millet DMS, it is smaller and very serviceable.

    However it does seem to have some noticeable POA/POI shift going from 1X to 4X so I zeroed at 4X and then shot a group at 1X and dialed in half the shift which makes the difference negligible for my purposes (shooting steel plates) I like 1X for the fast shots at the larger plated and 4X for the smaller plates or at longer ranges.

    I've only used mine on a 5.56x45 so I won't make any claims about durability, but so far so good for me. The turret setup is really pretty nice, but I never tried shooting the box adjustments and frankly think these type of turrets are overkill on a 1x4 scope where I'm going to zero using 4X at the "point blank" range and then use the mil dots for any holdover/windage.

    If you can afford better the Millet DMS at 2X+ or the Trijicon Accupoint at 6X the cost are better.
     
Thread Status:
Not open for further replies.

Share This Page