Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

choke tubes?

Discussion in 'Shotguns' started by BilboTN, May 29, 2005.

Thread Status:
Not open for further replies.
  1. BilboTN

    BilboTN Member

    Joined:
    Dec 10, 2004
    Messages:
    51
    Location:
    Knoxville TN
    Can someone tell me more about chokes such as the sizes and what each means? My new Winchester 1300 Walnut Field came with a couple of chokes so what should I keep in it for HD situations and what would I use for trap? I'm still learning about all the SG lingo.


    Thanks
     
  2. Dave McCracken

    Dave McCracken Moderator In Memoriam

    Joined:
    Dec 20, 2002
    Messages:
    13,938
    Location:
    MD.
    A search of the archives will give you tons of input. Here's a brief overview.

    CHokes for HD is nigh meaningless due to the close nature of confrontations. Even the most open choke has little spread over room sized range.

    Most choke sets run something like Improved Cylinder, Modified,and Full choke.

    IC is the most open. Full for the longer shots, and Modified in between.

    Modified is your best bet for starting out at trap, but Full will get you on them tighter and faster.

    HTH....
     
  3. RUT

    RUT Member

    Joined:
    Mar 29, 2003
    Messages:
    1,013
    Location:
    New Hampshire, USA
    >>IC is the most open<<

    Actually, "cylinder" is the most open, followed by "skeet"....... :)
     
  4. Dave McCracken

    Dave McCracken Moderator In Memoriam

    Joined:
    Dec 20, 2002
    Messages:
    13,938
    Location:
    MD.
    Actually, Rut, cylinder is more open but when did you see one in a 3 tube set? Given the chokes he most likely has, IC's the most open.
     
  5. Gordon

    Gordon Member

    Joined:
    Dec 26, 2002
    Messages:
    8,110
    Location:
    central Kali.
    Most Win chokes Imp Cyl throw excellent patterns with buckshot or slugs. I have had them since the late 70's on my 870s and 1100s. Blasphemy I know, but they were the only internal choke available at the time!
    The only thing to know about them, besides smearing them with a small amount of antiseize compound before tightening them snugly with the factory tool is that when you change them between different tubes(even of same constriction) :) you may get a pretty good pattern shift!
     
Thread Status:
Not open for further replies.

Share This Page