Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

COAL all over the place Ranier Ballistics 124gr RN

Discussion in 'Handloading and Reloading' started by HK SD9 Tactical, Jul 5, 2011.

Thread Status:
Not open for further replies.
  1. HK SD9 Tactical

    HK SD9 Tactical Member

    Joined:
    Jan 10, 2009
    Messages:
    117
    Location:
    Florida
    As title says. I am using my Hornady LnL for 9mm loading 5.8gr of Ramshot Silhouette under a Ranier Ballistics 124gr copper plated round nose (their are marketed as Ranier LeadSafe Bullets 9mm (.355 diameter) 124 grain Plated Round Nose case of 1000 UPC 0238132210 - bought through MidwayUSA). Seems every thing is working on the LnL however, my AOLs are all over the place. I am shooting for 1.160in and I am getting anywhere from 1.153in to 1.176in.

    So I called Hornady and explained the situation to them. I questioned whether the New Dimension Dies are the problem. I told them that I was using the round nose stem insted of the flat nose stem in the seating die and asked whether I should switch over to the flat nose seating stem to ensure my COAL were all the same. I was told no and that the COAL were not all that important on the RN bullets because the ogive was going to vary.

    I understand the variance in the COAL that RN bullets can cause however the variances are way to much for my taste. If I use the round nose stem my COAL are gong to vary (it should not be more than +/- .003 though) but I am way out in the ballpark right now. If I use the flat nose stem to seat, I can achieve a stable 1.160 but now some of the bullets will be sitting considerably back from the lands.

    Apparently the ogive on this batch of RN bullets varies quite alot. While the variance is not too significant for my H&K SD9 Tactical, I also will be shooting these out of a IMI baby 9.

    So, should I go for the stable COAL of 1.160in using the flat nose stem or should I let the variance not bother me due to the ogive on these bullets using the round nose stem?

    TIA
     
  2. Walkalong

    Walkalong Moderator

    Joined:
    Nov 20, 2006
    Messages:
    48,834
    Location:
    Alabama
    Yep, +/- .003 is acceptable, but 1.153in to 1.176in is way too much. My guess is the seater plug does not fit the nose very well.

    Some folks here have come up with ingenious ways to make it fit, filling the plug with anything from hot glue to epoxy and forming it to the bullet.
     
  3. HK SD9 Tactical

    HK SD9 Tactical Member

    Joined:
    Jan 10, 2009
    Messages:
    117
    Location:
    Florida
    I have a hot glue gun. I'll give that a try to see if that will take some of the variances out.
     
Thread Status:
Not open for further replies.

Share This Page