Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Composite stock?

Discussion in 'Rifle Country' started by LowFlyer, Nov 21, 2004.

Thread Status:
Not open for further replies.
  1. LowFlyer

    LowFlyer Member

    Joined:
    Dec 15, 2003
    Messages:
    10
    My Browning composite stock has sharp edges along the mold die lines. Is there a way to remove these edges without doing it with a razor knife. A knife would do the job but would be unsightly. Is there some type of buffing wheel to do this job?

    I would also like to know if anybody knows of any aftermarket suppliers for a camo, or wood stocks for the A-Bolt?
     
  2. shoobe01

    shoobe01 Member

    Joined:
    Mar 4, 2004
    Messages:
    417
    Location:
    Kansas City
    Sand them. By hand, or it will get too hot. And then it will look a little crappy, so you paint it. Works great. Painted plastic always looks better than moulded color plastic itself.

    Use the plastic paints Krylon and others have out now. Follow all instructions for surface prep and dry time it will last forever.
     
Thread Status:
Not open for further replies.

Share This Page