Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Cz 52

Discussion in 'Firearms Research' started by Byron Quick, Jan 4, 2003.

Thread Status:
Not open for further replies.
  1. Byron Quick

    Byron Quick Moderator In Memoriam

    Joined:
    Dec 21, 2002
    Messages:
    6,482
    Location:
    Waynesboro, Georgia
    I recently purchased a CZ 52 chambered in 7.62 X 25. After about three magazines were fired, the pistol failed to fire several times. Upon examination the firing pin is not indenting the primers. Apparently, the firing pin has broken. I have heard that is a recurrent problem with this model.

    Harley, do you:
    1) Have the disassembly instructions for this pistol?

    2) Do you (or any of you guys) know of a source of firing pins?

    Thank you.
     
  2. TexasVet

    TexasVet Member

    Joined:
    Dec 24, 2002
    Messages:
    402
    Location:
    deep east Texas
  3. Byron Quick

    Byron Quick Moderator In Memoriam

    Joined:
    Dec 21, 2002
    Messages:
    6,482
    Location:
    Waynesboro, Georgia
    Thanks!
     
  4. Tropical Z

    Tropical Z Member

    Joined:
    Jan 8, 2003
    Messages:
    1,552
    Location:
    The path less chosen...
    And don't dry fire your replacement pin!
     
  5. Gewehr98

    Gewehr98 Member

    Joined:
    Dec 24, 2002
    Messages:
    5,988
    Those replacement firing pins...

    I have one, a spare, for my CZ-52. Supposedly a better piece of steel, so dry-firing isn't the problem it was with the older version. I'll have to give it a try and report back.
     
  6. Jagermeister

    Jagermeister Moderator In Memoriam

    Joined:
    Dec 23, 2002
    Messages:
    371
    Location:
    Brunswick GA
    Gewer98:
    Regrets Pal, don't have them.

    JM:(
     
Thread Status:
Not open for further replies.

Share This Page