Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

CZ trigger question

Discussion in 'Handguns: Autoloaders' started by wbwanzer, Feb 7, 2009.

Thread Status:
Not open for further replies.
  1. wbwanzer

    wbwanzer Member

    Joined:
    Dec 12, 2006
    Messages:
    1,158
    I saw on another thread where someone suggested a Competition hammer for an SP-01 to improve the trigger. Would a Competition Hammer be able to be 'dropped in' to a P-01 with the decocker? And if so, does 'drop in' mean drop in for a gunsmith type or drop in for a novice? Obviously I'm the latter when it come to working on guns.
    Thanks for any help.
     
  2. eerw

    eerw Member

    Joined:
    Jan 5, 2003
    Messages:
    730
    Location:
    AZ
    the comp hammer would need to be modified for a decocker gun.
    one side needs to be cut away to allow it to work with the decocking lever.
    once that is done it would improve the trigger quite a bit.
     
  3. burningsquirrels

    burningsquirrels Member

    Joined:
    Apr 1, 2008
    Messages:
    1,562
    Location:
    Georgia
  4. wbwanzer

    wbwanzer Member

    Joined:
    Dec 12, 2006
    Messages:
    1,158
    Thanks for the info. Sounds like it's beyond what I can do.
     
  5. NG VI

    NG VI Member

    Joined:
    Dec 12, 2007
    Messages:
    4,884
    Location:
    Maine
    You might be able to get a decocker-specific comp hammer from Ghost Custom, I saw they had some last spring but when I went to order they were all gone.
     
  6. JDGray

    JDGray Member

    Joined:
    Sep 16, 2005
    Messages:
    5,131
    Location:
    SW MI.
    Replace your hammer spring with a lighter one. A 17# would lighten the trigger quite a bit. People run 15# without problems, but wouldn't carry it for ccw with it.
     
Thread Status:
Not open for further replies.

Share This Page