Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

CZ75 sp01 mini trigger job

Discussion in 'Handguns: Autoloaders' started by Bazooka Joe71, Oct 24, 2006.

Thread Status:
Not open for further replies.
  1. Bazooka Joe71

    Bazooka Joe71 Member

    Joined:
    Aug 21, 2006
    Messages:
    2,803
    Location:
    Southern Indiana
    I just recently purchased a CZ 75sp01, and the trigger is a bit gritty...I was planning smoothing out the sear, Ejector and Trigger Bar from any of the machining marks made by the factory. I haven't really ever had to do this before, so I was just wondering what would be the best thing to use when smoothing them out.

    Pardon my ignorance, but if its sand paper, then how rough should I use.

    Thanks in advance guys/gals!
     
  2. The-Fly

    The-Fly Member

    Joined:
    Nov 1, 2005
    Messages:
    897
    Location:
    Northern Colorado
    buddy of mine has the same gun. Put a 1000 rounds through it, and the trigger will get VERY smooth.
     
  3. mxl

    mxl Member

    Joined:
    Oct 12, 2006
    Messages:
    138
    I prefer 600 or 800 grit. Sand in the direction of movement. :)
     
  4. CZguy

    CZguy Member

    Joined:
    Mar 25, 2004
    Messages:
    3,976
    Location:
    Missouri
    Or use a snap cap and just dry fire the heck out of it.
     
  5. HorseSoldier

    HorseSoldier Member

    Joined:
    Jul 13, 2006
    Messages:
    5,297
    Location:
    Anchorage, AK
    +1 to the shooters.

    Before I started sanding on anything, I'd try working with it with snap caps and putting a good number of rounds downrange. CZ triggers get better with use. My SP-01 was midly gritty when I bought it, but after several heavy workouts on the range, that grit was pretty much gone.
     
Thread Status:
Not open for further replies.

Share This Page