Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Did a little work on the 1911

Discussion in 'Handguns: Autoloaders' started by dixierifleman, Dec 17, 2008.

Thread Status:
Not open for further replies.
  1. dixierifleman

    dixierifleman Member

    Joined:
    Jan 18, 2007
    Messages:
    124
    Well I started to trim out my parkerized GI with stainless. I love the look so far. It's not all cosmetic, though. With the new barrel bushing, it shoots better and feels tighter. The extended mag release is nice too, with the wider hogue grip. Next up, is a stainless mag well. I have it along with a stainless commander hammer(need a new GS), and a trigger. Just haven't had the time to take the lanyard loop off the spring housing and fit the trigger. And I'm also going to put a new slide stop and thumb safety on it.

    [​IMG]
    [​IMG]
     
  2. parrothead2581

    parrothead2581 Member

    Joined:
    Aug 14, 2007
    Messages:
    31
    Looks good!

    I'll gladly take that arched MSH with the lanyard loop off of your hands. ;)
     
  3. franconialocal

    franconialocal Member

    Joined:
    Oct 21, 2008
    Messages:
    673
    Location:
    New Hampshire
    Nice job.....gives me some good ideas.
     
Thread Status:
Not open for further replies.

Share This Page