Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Dirty 38 SIP Ammo

Discussion in 'Handloading and Reloading' started by Larry Noble, Oct 5, 2005.

Thread Status:
Not open for further replies.
  1. Larry Noble

    Larry Noble Member

    Joined:
    Aug 23, 2005
    Messages:
    1
    Location:
    Naples, FL
    I have about 10 boxes of ammo, 38SIP, that was packed away and termites
    got in and ate the boxes away. They also left a termite residue on the casing
    in the primer area. This residue will come off if sprayed with WD40 and
    rubbed. Would it be safe to dump all the ammo in a bucket and soak in some
    liquid. What would be safe to soak then in? Mineral spirits,Turpentine, or what
    else? OR would it be best to just dispose of them
     
  2. Sam

    Sam Member

    Joined:
    Jan 1, 2003
    Messages:
    1,384
    Location:
    Alamogordo, New Mexico
    Welcome Larry,
    It would be safe to dunk them in some cleaning solvent, but it would ruin the ammo. No telling how long it would take, could be seconds for some, days for others. WD40 has an especially bad reputation around here for kiling primers.

    I would put my grandchildren to work on it with 0000 steel wool if I needed to keep them quiet for an hour or two.

    If they would chamber, I'd put 'em in my 28 and practice my hip shooting.

    Sam
     
  3. Primersinmyshoe

    Primersinmyshoe Member

    Joined:
    May 29, 2005
    Messages:
    266
    Location:
    St. Louis, Mo
  4. only1asterisk

    only1asterisk member

    Joined:
    Jun 13, 2003
    Messages:
    2,412
    Standard Issue Police?

    David
     
  5. The Bushmaster

    The Bushmaster Member

    Joined:
    Jan 29, 2005
    Messages:
    7,850
    Location:
    Ava, Missouri
    I knew that!!! Unless they have collectors value, I'd just render them safe and disgard them....38's are cheap. Why spend that kind of labor to clean what you can load or buy cheaply... :scrutiny:
     
  6. Ky Larry

    Ky Larry Member

    Joined:
    May 22, 2003
    Messages:
    3,526
    Location:
    Ky
    If you are a reloader, you could pull the bullets, dump the powder, and tumble the brass clean. If you fire the primed cases, clean your gun thoroughly immediately afterwards. The primers may be corrosive. If the brass is corroded, I'd just dump the whole lot. .38 brass is cheap and plentiful. Good luck.
     
Thread Status:
Not open for further replies.

Share This Page