Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Does your AK hammer look like ...?

Discussion in 'Rifle Country' started by Brass Fetcher, Nov 11, 2006.

Thread Status:
Not open for further replies.
  1. Brass Fetcher

    Brass Fetcher Member

    Joined:
    Jan 11, 2006
    Messages:
    1,685
    Location:
    Eastern border of the United States
    Hi everyone. I have a Romanian AK-74 clone and a question about an indention in the hammer of the weapon. Is it normal for an AK series rifle to have an indentation in the face of the hammer, where the rear of the bolt/bolt carrier strikes it to recock the hammer?

    I am suspecting that the answer is 'no' and that this is because the hammer is a compliance part, with bad heat treatment/material causing a soft hammer.

    Anyways, thank you for the help.

    JE223
     
  2. flip180

    flip180 Member

    Joined:
    Feb 10, 2004
    Messages:
    722
    Do you have a SAR or a WASR? If you have a SAR, you have a cheap american made hammer to help comply with the number of U.S. made parts that it needs. They are known to be soft and sometimes end up with that dent. If you have a WASR then, you should have a Tapco G-2 trigger group and, that shouldn't be happening.

    Flip.
     
  3. Brass Fetcher

    Brass Fetcher Member

    Joined:
    Jan 11, 2006
    Messages:
    1,685
    Location:
    Eastern border of the United States
    I hope your shooting is as precise as your answer. It is a SAR, '2' I guess.

    Thank you for the help.

    JE223
     
  4. Glockfan.45

    Glockfan.45 member

    Joined:
    Sep 7, 2006
    Messages:
    1,369
    Location:
    Democratic Peoples Republic of Illinois
    My Romanian WASR 10 has no such dent in the hammer. It is a 7.63x39 if that makes any difference.
     
  5. flip180

    flip180 Member

    Joined:
    Feb 10, 2004
    Messages:
    722
    Check the right front of your receiver just under the charging handle. It should say what it is there. Also look on both sides of the receiver. There should be dimples on the each side where the mag well is. If there are dimples there then, it is a "Sar" series AK. If it is a "Sar" series AK, I'd ditch the FCG and get a Tapco FCG along with a sheppards crook to hold all of the pins in. That was the best thing I ever did with my Sar-1 when I still had it.

    Flip.
     
Thread Status:
Not open for further replies.

Share This Page