Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

EOTEC sight in procedure?

Discussion in 'Shooting Gear and Storage' started by chestnut ridge, Apr 17, 2009.

Thread Status:
Not open for further replies.
  1. chestnut ridge

    chestnut ridge Member

    Joined:
    Aug 18, 2005
    Messages:
    321
    Location:
    south central Tennessee
    I found the elevation and windage adjustments to be uncertain.
    Not much change; then way too much. What is the best method
    for sight in with this device?
     
  2. rcmodel

    rcmodel Member in memoriam

    Joined:
    Sep 17, 2007
    Messages:
    59,082
    Location:
    Eastern KS
  3. chestnut ridge

    chestnut ridge Member

    Joined:
    Aug 18, 2005
    Messages:
    321
    Location:
    south central Tennessee
    thanks, that will save ammo. Three shot groups cost one dollar.
     
  4. Dulvarian

    Dulvarian Member

    Joined:
    Mar 5, 2009
    Messages:
    334
    Location:
    South Carolina
    Making sure that you apply pressure on the side of the sights when applying get you close to the factory center. First mount while not following that step left me about three inches right on point of impact at about ten yards. Kinda weird that I had to do that, but it made a huge difference.
     
  5. rcmodel

    rcmodel Member in memoriam

    Joined:
    Sep 17, 2007
    Messages:
    59,082
    Location:
    Eastern KS
    Just goes to show, not all mil-spec rails are mil-spec.

    rc
     
Thread Status:
Not open for further replies.

Share This Page