Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Extractor for Mauser Pocket Pistol

Discussion in 'Gunsmithing and Repairs' started by winwun, May 5, 2003.

Thread Status:
Not open for further replies.
  1. winwun

    winwun Member

    Joined:
    Apr 26, 2003
    Messages:
    225
    Location:
    Blount County in East Tennessee
    Seriously and diligently searching for an extractor for a .25 Auto Mauser 1910 "Side Latch" The extractor is appx one and three eighths inches long. Have tried all the normal sources - Marstar, Bob's, Numrich, even the Mauser guy in Austria. Put me on the right track and I'll buy your lunch and wash your pick-up.
     
  2. Greg G

    Greg G Member

    Joined:
    Dec 28, 2002
    Messages:
    19
    Try Tom Heller at hellerarms@webtv.net. If he doesn't have it he might know of some other places to try.
     
  3. Jim K

    Jim K Member

    Joined:
    Dec 31, 2002
    Messages:
    17,754
    I won't say they can't be gotten, but the last one I installed I had to make.

    Jim
     
  4. winwun

    winwun Member

    Joined:
    Apr 26, 2003
    Messages:
    225
    Location:
    Blount County in East Tennessee
    Jim, what would you charge to make and install one for me? This is a very serious inquiry. If you don't want to post on the forum, e-mail me.
     
Thread Status:
Not open for further replies.

Share This Page