Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

FEG PA-63 feed ramps

Discussion in 'Gunsmithing and Repairs' started by db_tanker, Nov 5, 2006.

Thread Status:
Not open for further replies.
  1. db_tanker

    db_tanker Member

    Joined:
    Apr 22, 2005
    Messages:
    1,772
    Location:
    Willis, TX
    I was wondering if anyone worked on the feed ramp on these little pistols? Polish them up and such....I picked up 150 rounds of HP Silverbear and it doesn't feed for crap...go in there with a craytex wheel mebbe to polish it up first?


    D
     
  2. PotatoJudge

    PotatoJudge Member

    Joined:
    Nov 17, 2005
    Messages:
    1,332
    Location:
    Texas
    DON'T DO IT!!
    Polishing the ramp will probably not fix the problem, and will most likely ruin the frame. Try new springs or a diffferent magazine, or at worst find some FMJ load it will be reliable with.
     
Thread Status:
Not open for further replies.

Share This Page